“You don’t need a sledgehammer to bust up concrete, not to mention jackhammers or explosives. All you need is to drill some holes, pour in some Ecobust slurry, and give it a little time.
“I had a 6-in. thick, 3-ft. square slab that had been poured on to an existing floor. I needed to clear it out for a renovation.
“Ecobust suggests drilling 1 1/2-in. dia. holes, 80 to 90 percent of the way through the block of concrete. The company also suggests drilling the holes every 12 to 14 in. in concrete without rebar or other reinforcing.
“Not one to follow directions exactly, I drilled a crisscross pattern in the pad and used a 1-in. bit, as I didn’t have a 1 1/2-in.
“I did follow directions on the slurry. Although I found it hard to imagine a little more than 3 pints of water could dissolve 5 lbs. of powder into a slurry, it did.
“What I ended up with was a great deal more than I needed. I filled the holes and was amazed how quickly the slurry began to thicken and set up.
“ The company warns that the slurry can react so fast that it can blow out of the holes. Mine didn’t do that. However, the directions suggest stirring it to remove any air pockets. When I did, I found the first holes filled were already solidifying.
“I covered the slab with a tarp and checked it 24 hrs. later.
“The solid slab had broken along the lines of the holes just as promised. My only regret was that I hadn’t drilled more holes and used more of the slurry. Some of the chunks were still pretty heavy.”
“I did have 2 frustrations with the company website. First was an inability to get anyone to answer a phone call during the workday. My other frustration is the examples offered. The closest to my situation was a 4 by 4-ft. pad, 16 in. thick. The picture showed 16 holes drilled and suggested that 44 lbs. of powder should be used. Based on my experience, that amount would seem to be extreme overkill and a waste of money. But then, the resulting pieces likely weren’t as heavy as mine.”