“Glenwood boilers have been best buys twice for me. I put a hot air unit in my house 21 years ago. It still works fine, but I wanted hot water for in-floor heat in the shop where I run my business, Shores Tractor Repair.
“I had a new Glenwood 7060 installed in an old cement block milk house about halfway between my house and my shop that I operate in a remodeled barn.
“John Kreider, Glenwood Heaters, installed the 7060 and ran hot water lines to the shop and to the house. In the house, the hot water travels through heat exchangers in a water heater and the plenum of my older Glenwood. We have all the hot water we can use, and the house stays comfortably warm all the time. If the temperature dips, the thermostat turns on the fan and it warms right up.
“I like the fact that installing the heat exchanger didn’t affect my older stove. That means I can use it if I shut down the boiler in the milk house.
“The Glenwood can be set up for almost any kind of fuel. The one in the house is set up to use wood, coal or fuel oil. If we go away in the winter, we just switch it to fuel oil, and the house stays warm.
“I keep costs down by burning skid pallets, cardboard and paper from a second family business spring and fall. Last year, I burned pallets and paper most of the winter. This year I may add a coal burner for the colder weather.
“It’s amazing how much heat comes from burning that waste. The Glenwood has a secondary burn chamber, and the amount of ash is unbelievably low. There’s definitely less smoke than with the traditional outside boiler.
“I had previously used a fuel oil boiler to heat the shop floor. With the waste fuel I use now, I wish I had added the new boiler earlier.
“We’re saving between $4,000 and $5,000 a year in fuel alone.”