“My worst buy was my Husqvarna LGT 2654 garden tractor. I bought it at Lowe’s to replace my 15-year-old MTD 18 ½ hp tractor, which I had been using to do the jobs I can’t or don’t want to do with my Farmall Cub.
“We live on a mountain farm and over the years I used the MTD to haul, mow, push snow and transport my log splitter from one site to another. I never had any trouble on slopes of 16 to 18 degrees. However, soon after I started using the Husqvarna I was pulling the log splitter up a slope when the tractor just stopped pulling and began rolling backward. I was able to stop it, but it wouldn’t go forward again.
“After I disconnected the splitter and moved it out of the way I was able to roll the tractor back downhill to a level place and restart it, and then it ran fine. Before going back up the slope to get the splitter, I went down to the shop and ran the hydrostatic transmission bleed procedure. After that it ran fine – until last spring when I was pulling a small trailer loaded with ashes from our wood furnace up a slight incline. This time I couldn’t decouple the trailer and had to get my 4-WD truck to pull the tractor and wagon back to level ground. Then it worked fine again. But a few days later, the same problem happened again.
“I called the company and they said the maximum slope for the tractor was 15 degrees. It’s a safety issue and not a mechanical one, but the company takes no responsibility if you use their product on slopes of more than 15 degrees. I emailed the transmission manufacturer (TuffTorq), and they said the unit is designed for 18-degree slopes.
“The bright spot in all of this is that after eight months and putting 25 hours on the tractor, Lowe’s simply said ‘Bring it back. We’ll return it to Husqvarna’. They did, and I put my old MTD back in service, mowing, towing and generally going up and down hills with no problem.
“My Ramsplitter is a best buy (Tri-D Mfg., ph 815 968-4014). I have the 16-ton model which splits anything I can fit into it. So far the largest piece I’ve split has been about 30 in. in diameter. It’s a hardworking machine that starts easily and works well. Great support from the manufacturer, too. One of the wheels broke at the hub soon after I began using the machine. I emailed the company and they brought a complete new wheel and tire to replace the bad one, no questions asked.
“I bought a Wood Master 4400 outdoor wood burning furnace last year to replace our Taylor stove (ph 218 253-4328; www.woodmaster.com). Where the Taylor model had a 750-gal. water jacket, the Wood Master has 117 gal. And where the Taylor needed monthly cleaning to keep creosote from closing the heat exchange tubes, the Wood Master worked all winter (actually from the end of August to the first of June) without significant creosote build-up. I only had to remove the ashes twice before I shut it down.”