DeWalt 18-volt batteries
What FARM SHOW readers say · 18 Best Buys2 Worst Buys · Shop & Maintenance
DeWalt 18-volt batteries
18 Best Buys2 Worst Buys“Over 50 years ago, I bought a Waterloo toolbox with top and bottom for about $100. They were good old American-made. The drawer slides are nice and tight, better than most new ones are today. I can proudly say I’m using it to this day. To me, this qualifies as a ‘best buy.’
“In a recent FARM SHOW, a reader talked about tool batteries. I have several DeWalt 18-volt batteries from years back, but I couldn’t make the batteries last. I finally went with 20-volt adapters and batteries. They’d only work okay. I discovered the adapters were the problem. Spend the extra money and get the DeWalt brand. The cheap Chinese adapters didn’t last two seconds before they smoked. You get what you pay for.”
“My DeWalt 18-volt reciprocating saw is a sorry saw. It’ll run for about 1 min. and quit. I bought two new batteries, but they were no help.”
John says his 2014 DeWalt 18-volt drill is still going strong, despite being dropped 20 ft. and landing on concrete in zero-degree weather.
Rachel likes their 2019 DeWalt 60-volt grinder. “I have large hands for a woman but still have always struggled to control grinders. This model has a slim profile hand grip and a power switch that I can easily control. The grinder is well balanced and has an automatic shut-off if the wheel gets pinched.”
“My DeWalt 18-volt cordless metal cutting shears works great to cut long runs of metal roofing and sheet metal. It’s portable, quiet, and easy to control, and unlike nibblers or saws it doesn’t leave small metal shards.”
“All of my DeWalt 18-volt cordless tools perform well. I use the impact driver to drive in pole barn screws and T-25 screws of all lengths.
“I installed Greenteeth on my stump grinder and highly recommend them (www.greenteeth.com; ph 800 473-3683). The teeth are rotatable and replaceable. Each tooth provides up to 3 fresh cutting edges which results in a longer cutting life. You can rotate each tooth to a new cutting edge in just a few seconds using only a standard wrench. The teeth come in various sizes and cutting designs so you can match them to your grinder.
“I’m somewhat disappointed with my Honda PC 5000 portable gas-powered winch. It functions well and the little Honda engine runs amazingly well. However, the engine seems underpowered for the work it’s supposed to do and is painfully slow to snake a 10-in. dia. by 20-ft. pine log out of the woods. It definitely can’t handle an 18-in. dia. by 8-ft. long oak log, even when using a doubler. I do like the winch’s portability and virtually limitless rope length. And when hunting, it works well to pull big game out of the woods.”
“My 2013 GM 2500 HD extended cab 4-WD pickup has never been to the dealer for any problems. It has a quiet, comfortable ride. The 6.0-liter engine has a lot of power but still gets 16 to 17 mpg.
“My DeWalt 18-volt cordless drill has very poor torque when drilling metal. Also, the batteries didn’t last long so I constantly had to buy new ones. I finally got rid of it and bought a Milwaukee model. Now I have a high torque drill with batteries that will last a long time.”
“I bought my Bobcat 763 skid loader used 3 years ago and mounted a tree shear and brush grapple on it. I use this skid loader hard to cut cedar trees but haven’t had any problems. I’d buy another one.
“My DeWalt 18-volt impact wrench lacked torque, so I bought an Ingersoll Rand 24-volt model. Wow.”
“My DeWalt 18-volt cordless impact driver is small and easy to handle, yet has adequate power for most smaller jobs.”
“I use my DeWalt 18-volt impact wrench almost every day. It’s relatively light, has plenty of power and doesn’t break if I drop it.”
On the “worst buy” side, “My 2008 Dodge 2500 heavy-duty pickup equipped with a Cummins diesel engine wouldn’t pass inspection at 36,000 miles because the steering arms were shot. By the time the pickup had 50,000 miles, I had installed a new clutch, universal joints, and tie rod ends. I can’t keep the ‘check engine light’ off long enough to get 2 miles away from the dealer so I can trade it. This truck is junk.”
John’s the satisfied owner of a 2011 DeWalt 18-volt impact wrench. “I use this wrench on anything with big bolts and to remove nuts when changing tires. I like it because I don’t need an air hose or compressor and because it’s easy to take to remote locations. It has a lot of power as long as you have a good battery.”
Greg’s impressed with his DeWalt 18-volt cordless impact wrench equipped with a 1/2-in. drive. “I can’t believe how much torque this tool has. I use it everywhere, including installing dual wheels on my tractor. It’s an amazing tool.”
He’s disappointed with his Polaris 400 Sportsman 4-wheeler. “The day we picked this ATV up it overheated and we had to take it back to the dealer. The problem turned out to be a bad sensor. Since then, the machine has been back to the dealer about every three months. I bought a Polaris because everyone said they were indestructible. But this is the last one I’ll ever own.”
“I like my 2003 Chevrolet 2500 heavy duty Duramax diesel pickup equipped with a 5-speed Allison transmission. I bought it used from someone who had bought it to pull a 28-ft. fifth wheel livestock trailer. He had all the minor repairs and maintenance done at a local dealer and had taken good care of the vehicle. I’ve put about 25,000 miles on it with no problems. It starts without having to be plugged in at temperatures down to 13 below zero, and it pulls a heavy load.
“My DeWalt 18-volt cordless drill is my worst buy. The drill itself works okay but I don’t like the keyless chuck. One week after I bought the drill the chuck stripped, making it almost impossible to tighten or remove any bits. The company said it was my fault for over-tightening the chuck and wouldn’t stand behind the product. I think this drill should have more steel parts and fewer plastic parts.”
“I like my DeWalt 18-volt cordless drill, which is equipped with an extra battery. This drill can fall off an 8-ft. ladder onto a hard surface with no damage. Just put the battery back on and you’re in business.
“My 1995 Chevrolet K1500 extended cab pickup has more than 243,000 miles but has required only routine maintenance. This pickup still has the original engine, transmission, rear end, and ball joints. It’s driven on/off road every day.”
Ron’s pleased with DeWalt 18-volt cordless tools. “I’m a contractor so I really work these tools hard. I’ve never had to replace brushes or switches. The batteries wear out in time, but the tools perform perfectly.”
“My 2005 and 2006 DeWalt 18-volt cordless power tools are best buys. We build boat docks and have tried most of the other major brands, but DeWalt tools are by far the best.
“My 2001 Ford F-150 pickup is my worst buy. The transmission had to come out in 2005 with only about 43,000 miles on it. This pickup was used for everyday use with no hard miles on it. Even though the 36,000-mile warranty had only recently expired the company wouldn’t help. It cost me $3,600 to fix which was not acceptable. Now I own a Chevy.”
Clayton likes his DeWalt 18-volt impact driver. “As a building contractor, I build decks and other things like steel roofs that require a lot of screws. These impact drivers will drive a lot of screws per battery charge and stay engaged in the screwhead much better than a drill driver with less down pressure. That saves on screw tips, and also makes it easier for me at the end of the day.”
“I like my 2005 DeWalt 18-volt cordless 1/2-in. drive impact wrench. It has 300 ft. lbs. of torque. It’s real handy - I take it with me everywhere to remove wheels and to drive 3/8-in. lag screws when installing fence braces.
“My 2004 Alemite 12-volt cordless grease gun is convenient and works fast for greasing corn heads and combines.”
“My DeWalt 18-volt cordless drill/screwdriver is my best buy. It’s a strong, reliable, rugged tool with replaceable motor brushes. I’ve used other major brands of cordless drills and wasn’t nearly as satisfied with them as I am with this model.”
Eric likes his 1998 DeWalt 18-volt cordless drill. “When both of my 110-volt drills died, I decided it was time to get a cordless model. I can carry it anywhere on the farm and do basically any job a 110-volt drill will do. It has adequate power for any job. I’m well satisfied with it.”
Douglas counts his DeWalt 18-volt trim saw and Makita 12-volt drill as two “best buys”.
“The trim saw has lots of power and is very handy to use. It definitely needs two batteries so you never have to wait on a charge.
“My Makita has been with me for six years. It has been used for everything from barn roof repair to hanging curtains. It’s hard to believe how versatile it is.”
Own a DeWalt? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.