Xtreme Outdoor Power Equipment + 1 more
“I do repowers, and sometimes the customer comes up with stuff I don’t know about. I needed a new clutch, and a customer suggested I try one from Xtreme Outdoor Power Equipment. They make a billet- machined, heavy-duty clutch. It is a very nice unit.
“I agree with Dan Lien’s worst buy (Vol. 42, No. 1) that doing a repower on a garden tractor can be frustrating. Unlike Dan, I still do them, but I start out by telling customers that unless they have thousands of dollars to put into it, I won’t even start the job. If the tractor doesn’t have sentimental value and they’re not willing to pay, I won’t do it.
“I’m an aircraft and/or power plant certified mechanic, and I can’t estimate a price. I don’t know what I’ll have to modify outside of normal repairs. It takes extra time to design and engineer fixes to kits. Then there is the time needed to chase down parts.
“I had one customer who paid me $3,200 to replace a 17 1/2 hp. Kawasaki engine with a 20 hp. Briggs & Stratton on a John Deere 325. The shaft size was right, it bolted to the frame fine and the clutch went on with a new belt, pulleys and hydraulic hoses.
“However, the new engine kit came with a fuel pump, but not a voltage regulator. The Kawasaki regulator didn’t work with it. Luckily I had a Husqavarna in the scrap heap with the same type of plug, and it charged the battery fine. If not, I would have had to research model and part numbers and eaten up a lot of time chasing parts. How do you charge for that?
“If you buy the engine kit, you have to know what you are doing and have the skill level to install it. I’ve upgraded clutches and starter solenoids and swapped automotive-type fuse links for fuse blocks. I’ve also had to develop methods to lengthen choke and throttle cables.
“With the Briggs & Stratton, I also had to split out the throttle and choke cable. They came on one control, and you had to go to full throttle to get the choke. That means very high rpm’s, which isn’t good for a cold engine. I split the choke out with a separate knob so it could be on while the engine loafed along.
“Replacing cables can be tricky. On older machines the throttle cable often goes across the top of the battery, and acid fumes can rust and corrode it. I slide new throttle cables inside a plastic sleeve when they cross over a battery, which is a good idea for anyone to do.
“Fuel lines are a special problem, as they can be 20 years old and brittle. I’ve found I need to replace the entire line, not just patch it. I start at the tank and go all the way to the engine.
“Exhaust systems are another challenge. You have to know how to weld and fabricate tubing to make the exhaust fit where it needs to go.”

