“My best buy is my Deere 2555 MFWD tractor equipped with a Deere 245 front-end loader. It has about 5,000 hours on it. I’ve replaced the water pump and tachometer but otherwise it has been trouble-free. I use it primarily for loader work but I haven’t had to replace the clutch yet.
“My Deere 1360 rotary mower/conditioner, which I bought used, cuts hay in all conditions, wet or dry, tall or short, and at speeds up to 14 mph.”
On the negative side, Henry says his Deere 1219 sicklebar-type mower-conditioner, which he bought new, caused him “nothing but trouble”. “In heavy hay the reel wouldn’t turn. Instead, hay would wrap around the reel belt causing it to slip no matter how much tension was on the belt. In wet conditions, such as second cut clover, the knife would plug up constantly. I couldn’t go more than 4 1/2 mph in the field and usually spent more time going backward – in order to clear the knives - than going forward. I traded it in for a used Deere 1360 rotary mower-conditioner and it’s a best buy. I’ll never go back to a sicklebar mower again.
“My Breeze windmill is a worst buy. I wanted to use it to aerate my pond to improve the water quality for cattle and fish. Unfortunately, vibration caused the tail section to break off which allowed the blades to hit the mounting pole. The machine was still under warranty so I returned it to the manufacturer. However, instead of replacing the blades all they did was cut the damaged sections from the ends of the blades. This reduced the performance as it required higher wind speeds before it would turn. The bearing on the crankshaft is too light and will only last about four to six months before it has to be replaced. Now the machine has developed an air leak and won’t build pressure. I’ve replaced every bearing and seal on the machine and rebuilt the pump, yet I still can’t seem to get it to work properly. This machine has been nothing but a big waste of money and time.”