Staber: what farmers say
12 reports in FARM SHOW · 8 Best Buys4 Worst Buys
Staber washing machine
6 Best Buys3 Worst Buys“We bought a Staber washing machine after reading about it in FARM SHOW. My wife loves this machine. I’ll admit, I’ve replaced the bearings, but it was an easy job and much cheaper than buying a new one. All in all, it’s a great machine. They’re pricey, but I probably would’ve bought three or four store-bought machines if I hadn’t bought the Staber.”
“I looked forward to the arrival of our new 2006 Staber clothes washing machine with its supposed money-saving features. However, within the first year our troubles began. First, a set of bearings suspending the wash drum went out. The warranty covered the cost of new bearings, but I had to install them. Two or three years later another set of bearings went bad and I had to pay for those, too.
“The next problem was more expensive. A circuit board blew out and cost almost $300 to replace. Now the rubber diverter around the top is ripped, and I’m afraid to inquire about the price of a new part. I’m not a spring chicken any more so repairing this machine has become a burden. When I purchased this expensive unit I expected at least 10 years of trouble-free service.”
“I have about a dozen pairs of U.S.-made Danner boots, and they’re all great (ph 877 432-6637; www.danner.com). I’ve worn these shoes since 1994 and have 2 pairs that have been resoled twice. Chinese-made Danner boots are also available, but I have no first hand knowledge of them and won’t buy them. Unfortunately, you have to buy U.S.-made Danner boots online as most retailers won’t sell them in stores. The boots start at $200 and go up. However, once you invest in quality footwear you won’t buy cheap boots again.
“We bought a Staber washing machine after reading a lot of good things about it. These washing machines are made in the U.S., use little water, and are designed so the owner can easily repair them. Now I know why. We spent $1,000 to buy our machine a few years ago, and about a year later the pump motor went out. The new motor was about 60 percent bigger so it barely cleared the housing. That tells me the original motor was undersized from the factory. A year later another part on the machine broke.
“If you don’t get the detergent level just right, this machine will overflow. It’s easy for the load to become unbalanced, which causes a lot of vibration. That can cause the main seal to rip and the main flywheel to come loose. Also, the mounting on the flywheel became elongated and I had to repair the pot metal. I can’t afford a new seal.
“Often when loads get unbalanced the timer will trip up and stick. As a result, my wife can’t just put in a load and do other chores; she has to babysit the machine. Now the machine needs $500 worth of parts to get it working again, but I won’t put even one penny into it. For the money I’ve spent on this machine, it should have come with a boatload of spare parts.”
Eric says his Staber washing machine is his “worst buy”. “We were really impressed with the Staber design so we bought the machine. However, from day one it wouldn’t balance correctly. Whenever it went into the spin cycle it sounded like there were elves with rubber mallets trapped inside.
“The company reluctantly sent new struts to solve the problem but it didn’t help. The drum drive motor went bad when the welds in the tub leaked water. After talking to the sales manager, I learned the drum had a lifelong warranty and they sent a replacement. But the new drum’s drive motor went bad after only three days. The company sent a new one but it didn’t last any longer.
“Finally I emailed the company and also left a phone message stating we planned to buy a new washer within five days and to please contact me. They emailed me two weeks later detailing how busy they were with warranty issues. My wife and I really like our new Whirlpool washer, and I happily cut up the Staber model for scrap.”
“After reading about the Staber clothes washing machine in FARM SHOW, I started saving up for one because my old washing machine had quit working. There have been both positive and negative reports on this machine in FARM SHOW, but I bought one anyway (ph 800 848-6200; www.staber.com).
“Well, this machine kicks butt. I just finished doing a really big backlog of laundry with no problems. The machine uses very little soap, and I can fill it up full. There’s no destructive agitator, and it’s easy to set up. The machine is made from the highest gauge materials. I’ve used it to wash lined pants full of ‘dairy-air’, Carhart coats, insulated coveralls, and cement choked trousers, and all of them came out clean. No redo’s were necessary.
“The machine’s spin is intense so it has to be set exactly level on a solid floor. It’s a heavy machine, and getting it down the stairs was harder than getting the old machine up and out.”
“My 2007 Staber clothes washing machine, a stainless steel commercial large load model, is my worst buy. First, the delivery from UPS was a nightmare. Then once the machine was delivered and I hooked it up, I found that I couldn’t wash my queen-size comforter because it won’t fit in the machine. The stainless steel water hoses ‘installed from the factory’ were cross-threaded and leaked. The outside of the washer drum is growing mold and slime on it and stinks.
“Recently we started the machine up and came back to find it had stayed in the spin cycle for six straight hours. When we called the company to return the machine, we were told we’d have to pay to ship it back and we’d have to pay a ‘restocking fee’. So we’re stuck with it and have had to resort to washing big stuff elsewhere.”
“I like my Charmaster wood burning furnace (Charmaster Products, Grand Rapids, Minn. ph 218 326-6786; www.charmaster.com). My home is totally electric so this furnace keeps my utility bill way down in winter. One good firing of this furnace will keep our house comfortable for up to 24 hours or more.”
The Charmaster is a fully automatic forced air heating system. According to the company, it’s the only wood burning furnace that will convert wood into a glowing bed of charcoal. The airtight design also creates a secondary burn of gases, consuming far less wood than other wood furnaces, says the company.
“My Staber washing machine is a best buy (Staber Industries, Inc., Groveport, Ohio ph 800 848-6200). It’s a real soap and water saver, and is easy on clothes.”
“Anyone with tough laundry stains should try Zout stain remover spray. It’s amazing stuff (Dial Corp., Scottsdale, Ariz. ph 800 548-9770; www.zout.com).” The product is water-based, non-corrosive, non-flammable, and biodegradable. It removes stains, without chlorine or bleach. It’s also available in a squeeze bottle.
Jim also likes his Staber washing machine bought in 2001 (www.Staber.com; ph 800 848-6200. “There aren’t enough words to describe how great this water-saving machine works. It has a side-mounted drum but still loads from the top. Laundry is tumbled through a pool of water at the bottom of the drum, creating a water pumping action that forces soapy water through the clothes for better cleaning. Larger items like comforters and blankets that would never get clean in a traditional washer come out exceptionally clean, even though you only use about half as much detergent in this machine.
“A problem developed with the washing cycle right after the warranty expired. I called the company’s toll-free number and talked to a service rep, who said the problem was probably due to a computer board. They sent me another board free of charge, asking only that I send the old one back. I was able to easily install the computer board by myself. Problem solved.”
“We bought a Staber washing machine after reading about it in FARM SHOW. We like the fact that it uses much less water and energy. The salesman told us the machine was 100 percent guaranteed or we could get our money back. Unfortunately, the company does not appear to stand behind that guarantee.
”We paid $1,200 for the machine. When it arrived, the water would not drain out of the machine. We had to bail it out by hand after washing our first load of clothes. The company promptly sent out repair parts for us to install and we got it working. But then we discovered that if you use bleach, it does not get rinsed out of the machine. If you put in a load of colored clothes afterwards, the bleach ruins them.
“After damaging a couple batches of clothing, we contacted the company. At first they just told us not to use bleach, but we have a disabled daughter who uses a lot of medicine that gets into her clothes, and we need to be able to bleach it out.
“Now the company wants us to ship the machine back to them in Ohio so they can test it. But they won’t admit there’s a problem so we feel we could get stuck with the shipping cost and still have a machine that doesn’t work right. In addition, they never did send us the rebate check we were promised when we bought it. They say they’re waiting to see what happens with the machine. This company has been very difficult to deal with.”
Staber clothes washer
1 Best Buy1 Worst Buy“I like my Massey Ferguson 135 diesel tractor, Deere 4440 tractor, Gnuse 3-pt. mounted forklift, Honda generator, and Stihl chainsaw. They seldom break down and are easy to repair.”
On the negative side, “Hands down, our worst buy was a Staber clothes washer. It didn’t clean our clothes, and maintenance was also a problem. We had to replace the bearings, pump, a hose, pulley, belt, and motor, and we had electronic problems.
“Replacement parts for this machine are ridiculously expensive. For example, the pump is imported from Italy and the belt that drives it is one-of-a-kind and is available only from the company. Every time I call the company they accuse me of oversudsing, which seems to be the explanation for all the failures on this machine. Also, the company isn’t helpful about how to stop the machine from jumping around and making a lot of noise. Toward the end, the struts needed to be replaced; however, the frame was rotting out so instead we got rid of the machine.
“I got holes in my clothes from the very first time I used this washer. I think the door design on the basket was to blame. It was a stainless steel basket that came with a 20-year warranty, but it was already rusty after only 4 years.
“I now own a Speed Queen clothes washer which I bought used. I replaced the pump on it for $40 and the belt for $20. Best of all, now my clothes are clean again.”
“My 1997 Kubota 5400 tractor has about 2,088 hrs. on it and is easy to operate. I use it for baling hay, mowing pastures, driving in fence posts, pulling logs, and tilling my garden.
“My 2003 Staber clothes washer doesn’t extract water out of my clothes as well as other brands. It does save on water use – in part because whenever I needed to wash a comforter or a large load of clothes I took them to our local laundromat. The machine finally quit working completely. I didn’t have time to repair it myself, so I replaced it with an older model Maytag that I bought for $75 at an estate auction.”
Staber top load washing
1 Best Buy0 Worst Buys“We’re well pleased with our Staber top load washing machine (Staber Industries, Groveport, Ohio ph 800 848-6200; www.staber.com). It’s very efficient, using only a fraction as much water as other machines. My clothes are always clean and there’s no agitator to cause wear and tear on them. I use only one ounce of detergent per load. The extra cost of this machine has paid off in savings to our pocket book and to the environment. Best of all, it’s made in the U.S.
“My 2006 Jeep Commander is my worst buy. At first we were mostly pleased with it, except the V-6 engine wasn’t as fuel efficient as we had expected. Then we had problems with the electronics and there were noises, fluid leaks, and safety control issues. All this with well under 36,000 miles.”
Read every report in full
FARM SHOW has run reader Best & Worst Buys since the beginning.