“My cab from Original Tractor Cabs for my Kubota BX23S was very easy to install, and the parts were labeled to make assembly easier (www.originalcab.com; ph 800-247-5305). I purchased it for wintertime snow blowing and for easy removal at the end of the season for open-air operation. Upon assembly, I discovered the left door window was sewn in wrong. I contacted O.T.C., and the reps responded promptly to the mistake. A new door skin arrived five days later. I recommend this company to anyone looking for a less expensive option other than the hard cabs offered. So far, I haven’t had to use the heater included due to residual heat from the motor, even on a 16 F day.”
Mike’s experience with his Kubota B2822 snowblower’s electric chute actuator hasn’t been as positive. “I love my front-mount snowblower, but after having it for 3 years, I wish I would’ve ordered it with the hydraulic actuator. This electric one has been nothing but a headache. The wiring to the actuator motor was too short. If you swung the chute to a 90-degree angle to the right, it would pull the wires out of the connecting socket. This thing has gone through six relays in three years. I’ve pulled the wiring harness out and inspected every inch, looking for potential issues. I’ve taken apart every relay to see why they failed, and all had water in them, shorting out the relay. It’s mounted under the hood, so I can’t figure out how the water gets in. Plus, if I leave the relay in the socket, it kills the battery overnight. The blower unit is a best buy, but take my advice and get the hydraulic chute deflector.”