John Deere 466 round baler
What FARM SHOW readers say · 3 Best Buys0 Worst Buys · Farm & Livestock Equipment
John Deere 466 round baler
3 Best Buys0 Worst Buys“It has performed beyond my expectations,” says Michael about his Deere 466 round baler. “I’ve used it to make almost 10,000 bales. The only repair it has needed was to a drive chain. The 4-ft. bale width allows us to move hay up narrow roads without posing a danger to oncoming traffic.”
Charlie likes his older model Deere 466 baler, which hasn’t given him any problems in two years of use, putting up 400 tons of hay per year. “It bales every bale perfectly and never misses tying one.”
He’s also pleased with two Ford 5000 diesel tractors he owns. “One’s got 3,000 hours on it, the other’s got 2,00 hours on it. They never give us a bit of trouble and are easy on fuel.”
On the negative side, he’s disappointed with his 1998 Deere Saber lawnmower equipped with an 18 hp engine. “It breaks every time I set foot on it. First, it was the steering bar. Then it was a bearing out of the mower deck. Next, a cut-out switch went out on the engine and it wouldn’t start. We finally took it back and traded it for a 1998 Craftsman with 21 hp engine which we haven’t had any trouble with so far.”
A 1997 Deere 466 round baler heads Alex’s list of best buys.
“After more than 8,000 bales, this baler still makes the tightest, densest bales of any machine on the market. The computer controls so many functions that one rarely needs to leave the tractor seat during a full day of baling. The belts and splices are so tough that five of the six belts are originals. The other was replaced under warranty with no hassles. The mega-tooth pickup does an excellent job while baling at a typical speed of 8 to 10 mph.”
On the negative side, Alex has had problems with his H&S 430-bushel manure spreader.
“It’s made so cheaply our 20-year-old Knight spreader is in better shape. First, the hitch bent. Next, the beaters bent because they’re built so soft and thin. Then, the end-gate bent back so far it contacts the beaters when it’s raised. The bearings on the beaters went bad three times. The spreader is permanently in high gear because the shaft connecting the low gear sprocket broke in half. To top it off, the seals on the end-gate cylinders blew out because the cylinders are cheap. We replaced the seals only to have the same problem again. We ended up replacing the cylinders with after-market cylinders. The company told us they would pay to have the hitch reinforced at a local welding shop and that they would replace the beaters free of charge. Since having the hitch reinforced, we have been in contact with the dealer we bought it from but have heard nothing further from the company.”
Own a John Deere? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.