Andrew’s impressed with his 2015 Kubota RTV-X1120 utility vehicle equipped with a diesel engine. “It has plenty of power, and a hydrostatic transmission that’s smooth and provides engine braking whenever I release the throttle. When you consider the high payload capacity, I think this is the best utility vehicle out there.”
On the negative side, he lists his 2019 Vermeer 504R Signature round baler. “The dealer reviewed everything on this baler with me after the purchase. Once I got home, I noticed the sprocket that drives the rotor and pickup had excessive runout. The sprocket is bolted to a hex shaft on one end of the stripper roll. I used a dial indicator to measure the runout of the shaft and found that it had 0.035 in. runout. Also, the bearing mounting plate was flexing 0.010 in.
“The dealer ordered a new stripper roll and sent a mechanic to help me install it. The hex shaft on the new stripper roll measured 0.015, which was still more than I would like but better than before.
“The stripper roll was replaced under warranty. The Vermeer rep told the dealer that I was the only one with this problem, which I find hard to believe. If your Vermeer 504R baler is wearing out bearings on the right side of the stripper roll, you might have the same problem.
“The next problem I had to tackle was the design of the windguard on the crop pickup. Under certain conditions, such as when the pickup drops into a low spot while baling thick hay, the windguard gets pushed into the stripper roll. I was sent a set of check chains to keep this from happening, but it didn’t help. Then, I removed 5 in. from the end of each finger on the windguard and the problem was solved.
“This baler is well built, but I shouldn’t have to fix new equipment like I did.”