Gene A. Wagner, Concordia, Mo.: Gene isn’t pleased with his 1988 MasseyFerguson 390 front wheel drive tractor and 838 front-end loader. “The first time I used the loader it couldn't lift anything. For five months the company tried to solve the problem by installing bigger cylinders, etc. I was told they were designing a new loader and that I could exchange my loader for a new one, It took 11 months before they finally showed up with a new loader. The new loader has a quick-tach mount for changing loader tools but the latches are poorly designed and won't hold. About the time I get back to the seat they fall down. Sometimes this happens a half dozen times while I’m uying to change attachments. The loader itself won’tstay up and ‘leaks’ down so fast that it’s dangerous. “Then there's the tractor. The power steering doesn’t work when the tractor is sitting still, and when the loader is mounted the problem is even worse. The front wheels bind when I turn short, making it almost impossible to back up a 4-wheel wagon even with the front wheel drive locked out. The company installed a change-over kit, but it doesn’t help much. Because it’s so hard to disengage I leave it in 4-WD more than I should, which causes the front tires to wear prematurely, The bolts in the front hubs wouldn't stay tight so the company installed different parts in the hubs. The tractor was in the shop for 19 days. That's a lotof downtime for a tractor that was bought to do daily feeding. It's more downtime than I've had on some 20-year-old tractors that I still use. The belly bolts won’t stay tight. The company installed a different gasket but it didn’t help. The pto wouldn’t stop turning and I was told it was because I had used the tractor to pull a Bush Hog. It was repaired in December, but by the following spring we had the problem again even though I never had a rotary mower on it all winter, “Several problems make it a nuisance to operate. When the temperature gets close to 32 degrees it won’ start. It burns out thermo start units faster than I can replace them. overhauled the electrical system myself and now it usually starts until the temperature reaches 20 degrees. The fuel shutoff works so hard that I’ve broke one already. They cost about $30. If an accident occurred you'd never getit shutoff very fast. The seat is poorly designed, Itholds waterand doesn’t flip up, so if I get off to open a gate in snow orrain and don’thave asack with me, I have a wet butt when I get back on the tractor. First gear and reverse gear aren't synchromeshed as they should be for loader work, and the safety start switch is on the high-low range. What a waste of time. The first and reverse levers always have to be moved when I go into a shed. For a highpriced investment this is a very unsatisfactory tractor.”