John Deere 6620 combine
What FARM SHOW readers say · 1 Best Buy2 Worst Buys · Farm & Livestock Equipment
John Deere 6620 combine
1 Best Buy2 Worst Buys“Two years ago I bought a new Makita chop saw which is my best buy. I’ve used it hard and it has done a very good job.
“We bought a plastic bottom for the un-derfeed auger on our Deere 6620 combine. After only one year of use it wouldn’t stay in place. The dealer wouldn’t do anything about it.”
“I sold my Case-IH 7110 4-WD tractor to get rid of the payments and then I fixed up my Oliver 1855 tractor with a new engine, radial tires, and lights. I also mounted a White 105 cab on it. I’m very happy with it. It’s doing the same work we did with the 7110. “My 1984 Deere 6620 combine is my worst buy. Last year the rubber drain line at the bottom of the oil filter blew out, causing the engine to lose oil. We had to make repairs, including installation of a new crankshaft. The company should have used steel-braided line instead of rubber.”
Steven L. Brooks, New Windsor, Ill.: Steven's pleased with his 1983 Deere 6620 turbo dicsel flatland combine, but sys it could use a number of improvements. “It works very good on perfectly flat ground, but poor on slopes, Grain runs over the rear end of the sieve and onto the ground. I cut out grain saver fins above the chaifer inside an old White combine and installed them on the outside edges of the top and bottom sieves (featured in FARM SHOW'’s Vol. 12, No. 1). It lets me harvest three to four times faster on hillsides. The engine gauge should be mounted in front of the operator instead of behind him. The shutoff system that controls hot water for the heater doesn't work right. The dealer replaced our system, but the cab got even hotter than before. We finally installed a plumbing gate valve in the heater hose so that we now have real control over the heat and air conditioning. “The snapping rolls on our Deere 444 corn head are poorly designed due to lack of a lower support bearing. We have to replace the rolls every year. The fingers on our Deere 213 reel head are too short. By the time the fingers reach down to the lodged bean stalks, the reel bats are already shattering standing beans. The reel has a ‘caveman’ pin-and-hole cylinder height adjustment. It should have a cylinder stop spacer that simply snaps onto the cylinder rod.”
Own a John Deere? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.