Real farmers rate what they bought, from FARM SHOW MagazineSubscribe  ·  Free issue  ·  Send us your Best or Worst Buy
Subscribe to FARM SHOW
Home › John Deere › 410

John Deere 410 baler

What FARM SHOW readers say · 1 Best Buy1 Worst Buy · Farm & Livestock Equipment

John Deere 410 baler

1 Best Buy1 Worst Buy
Worst Buy
Tom Lamont, Maidstone, Sask. · Vol. 29, No. 4 (2005), p. 13

“I must hold the world record for breaking gearbox input shafts on a Deere 410 baler. I’ve owned this baler since it was new and have broken three shafts. After installing a steady bearing as close as possible to the clutch assembly, I discovered the problem had been caused by the improper machining of the clutch assembly. It had a wobble that caused it to wear.

“I found another clutch setup at a salvage yard which is closer to true, but not perfect. It was interesting to see that the original clutch friction plate had less wear than the one on my salvage part so I didn’t abuse it.

“Other complaints: the chain drive to the upper belt rollers was too light. I’ve replaced the single row no. 60 chain with a double row chain which has worked well. The upper belts have never tracked well. Why isn’t there an adjustment similar to a combine pickup? The 12-in. belts wore too quickly so I bought a set of four 8-in. belts, which should get away from the short lacing life caused by chaff build-ups behind the wider belts.

“Why isn’t there a rotating belt guide on the upper belts just above the compression roll, similar to the one on the lower belts? Forage gets between the side plates, pushing the outer belts into the center.

“When one lays out the extra money for green paint, one expects the engineering to be done already. If I could afford it, this baler would be treated to a paint job to match the color of the rims.

“Why do I keep this embarrassment to the engineering profession? Well, I’m scared to buy something else in case it’s worse. And to be truthful, this baler has made a lot of good bales over the years.”

Best Buy
Jim Hadwiger, Cherokee, Okla. · Vol. 21, No. 1 (1997), p. 16

Jim owns a 1988 Case-IH 7140 tractor. “It has a lot of comfort and power, but I wish the power steering system worked better so that it would be a little easier to turn. One problem is that I don’t have a dealer close by - I have to drive a long way to get parts. I use a Deere 410 backhoe on it and am well satisfied with it. However, I wish I could raise it higher - I can stack bales only three high.”

Own a John Deere? Tell FARM SHOW how it’s held up.

Your report could appear in a future issue.

Send your Best or Worst Buy

More John Deere products

John Deere 1780 split-row 2 best · 1 worstJohn Deere 4240 tractor 14 best · 1 worstJohn Deere 720 diesel 3 best · 0 worstJohn Deere M tractor 2 best · 1 worstJohn Deere L110 lawn tractor 1 best · 1 worstJohn Deere 3025E tractor 2 best · 0 worstJohn Deere 3020 diesel 16 best · 0 worstJohn Deere gas tractor 46 best · 5 worstJohn Deere 4020 diesel 62 best · 3 worstJohn Deere 1023E tractor with backhoe 1 best · 2 worstJohn Deere 2025R tractor 4 best · 0 worstJohn Deere 9300 tractor 2 best · 1 worstJohn Deere 110 garden tractor 11 best · 2 worstJohn Deere Gator 6x4 2 best · 0 worstJohn Deere 6400 tractor 15 best · 0 worstJohn Deere 4320 compact tractor 6 best · 2 worstJohn Deere 8120 tractor 2 best · 0 worstJohn Deere 425 garden tractor 16 best · 5 worstJohn Deere 955 tractor 1 best · 1 worstJohn Deere lawn mower 12 best · 2 worst

See all John Deere reports →