Real farmers rate what they bought, from FARM SHOW MagazineSubscribe  ·  Free issue  ·  Send us your Best or Worst Buy
Subscribe to FARM SHOW
Home › Harbor Freight › tools

Harbor Freight tools

What FARM SHOW readers say · 5 Best Buys2 Worst Buys · Power & Hand Tools

Harbor Freight tools

5 Best Buys2 Worst Buys
Worst Buy
Bill Priddy, Stephenville, Texas · Vol. 49, No. 6 (2025), p. 14

“Any tool that I ever bought from Harbor Freight turned out to be a piece of crap. I finally learned my lesson about products made in China.”

Best Buy
Dan Eagleton, Decatur, Neb. · Vol. 43, No. 6 (2019), p. 15

“I’ve been buying Harbor Freight tools for at least 40 years, and have noticed they now provide a better choice of power tools and shop equipment than in the past. The hand tools are also of better quality, and new stores are popping up everywhere. Harbor Freight tools have saved me a lot of money over the years. Check out their new tool cabinets on wheels - they’re as good as you’ll find anywhere.”

Best Buy
Richard McDonald, Maple Valley, Wash. · Vol. 39, No. 2 (2015), p. 14

“I use my Harbor Freight cordless oscillating tool to trim the bottom branches at my Christmas tree farm. It’s lightweight and the battery lasts a surprisingly long time. I also used this tool while rebuilding a rotted-out motorhome. I bought a second model so I can alternate batteries.”

Best Buy
Larry C. Miller, Harper, Kansas · Vol. 32, No. 3 (2008), p. 14

“After reading a number of FARM SHOW reports about Harbor Freight electric tools, here’s my experience regarding a 1/2 hp drill that I bought used on eBay. I didn’t know it was a Harbor Freight product until I received it. I was rather new at shopping on eBay at the time so I can blame my inexperience. However, it didn’t turn out all that bad.

“When I received the drill it did run for a short time but then it quit working. Rather than complain to the seller, I decided to check out the switch. I discovered a ground wire had come out of the wire terminal block that connected the ground circuit. That fix solved the running problem, but then once it would run for several minutes it would begin to smell hot so this time I checked the brushes. I found that one of the brushes hadn’t been inserted into the holder correctly, and because the brush didn’t contact the armature properly it caused a heating problem. Once I fixed that I haven’t had any more problems.”

Best Buy
George Schneider, Pioneer, Calif. · Vol. 32, No. 2 (2008), p. 14

“I often read negative comments about Harbor Freight tools in FARM SHOW. However, I have a different philosophy. I use Harbor Freight to buy tools that I don’t necessarily need on a long term basis. For example, instead of renting a 1/2-in. drill for two days at a cost of $10 a day, I’ll buy a cheap drill for $29 and toss it after I’m done with the job. That way I don’t worry about spending all my time renting and returning a rental. I don’t expect to find ‘professional’ tools at Harbor Freight in the first place.”

Best Buy
Ken Scharabok, Waverly, Tenn. · Vol. 27, No. 4 (2003), p. 15

“In our area, when you go to a small engine repair shop to have a chain saw’s teeth sharpened, they take off so much of the teeth that after three sharpenings the chains are about useless. So I bought a ‘Nick the Grinder’ over eBay (www.eBay.com), which turned out to be a Harbor Freight tool (www.harbor freighttools.com). It’s my best buy. While it may look like a toy, it’s a serious piece of equipment that’s simple to set up and use. I can take off as little of the teeth as required, meaning I can get several times the number of uses out of a chain compared to ‘professional’ sharpening. I estimate this machine will pay for itself in only one season of woodlot management and firewood cutting.”

Worst Buy
Joseph deNatale, Pittsfield, Maine · Vol. 26, No. 2 (2002), p. 17

Joseph says Harbor Freight tools are his “worst buy”. “I’ve purchased several of the company’s tools for use in my apple orchard. Even though their tools are priced cheap they’re usually okay for occasional use. However, when some of the tools became defective I soon discovered the company’s customer service leaves a lot to be desired.

“I bought a titanium-plated drill bit set and a cold chisel set. Several of the drill bits were so soft I could bend them by hand, and when I used some of the chisels they shattered. I sent the tools back to the company and asked for replacements. I also told them about some significantly dangerous manufacturing defects that I had noticed in the tools so they could correct them for future buyers. The company never replied, so I wrote them a letter asking about the status of the returned items. They sent back a form letter that told me to call their customer service department. I called them and was told that all customer service representatives were busy. I waited more than 40 minutes before I became to springtime – you need to recalibrate the impatient and finally hung up. I sent three more letters to them but never got a written response. I was always referred by form letter to their customer service department.

“After writing four letters and spending a total of more than 2 1/2 hours on the phone waiting to talk to someone, I finally got through. The person I talked to said they couldn’t find the tools I had returned. The entire experience was an exercise in frustration.”

Own a Harbor Freight? Tell FARM SHOW how it’s held up.

Your report could appear in a future issue.

Send your Best or Worst Buy

More Harbor Freight products

Harbor Freight Bauer mini chainsaw 1 best · 1 worstHarbor Freight 4 1/2-in angle grinders bend 2 best · 3 worstHarbor Freight Predator engines 1 best · 1 worstHarbor Freight 10-ton hand-pumped log 2 best · 0 worstHarbor Freight 1/2-in drive 1 best · 1 worst

See all Harbor Freight reports →