Lamar Faught, Jonesboro, Ark.:
“Within the first year of use, the
power steering pump went bad, the
carburetor had to be worked on several times and it wouldn't run very
well with all of the pollution control
equipment on it. The heater core had
to be replaced, along with the rear
“With only 45,000
miles, it has me
wondering what’s going
to go wrong next.”
shocks and transmission valve body,
This prompted the purchase of an extended warranty before the truck
reached one year of age,” says Lamar,
upset with his 1979 Ford F-250
pickup with a 400 engine.
“Since then, the warranty has paid
for the removal of the left head because it was warped, the replacement
of two water pumps, the first of which
was faulty. There was also a hole in
the body that allowed rain water to
run into the heater system. This
caused the defroster to fog the windows over instead of clearing them
off. All of these problems happened
before 25,000 miles.
“Since then the radiator has had to
be cleaned out 3 times, the fuel pump
replaced, and the front springs replaced because they allowed the front
end to sag and the wheels to ride on
the spring brackets. Dealer service
has been very good but only about
half the problems have been covered
by the extended warranty. With only
45,000 miles on it, it has me wondering what's going to go wrong next.”
Lamar’s had better luck with his
Bush Hog 256 3-pt. hitch attaching
rotary cutter, “For the price, it's the
heaviest-built mower we could find.
It does a very good job on grass and
brush, leaving a clean path behind
it,”
the injector pump auxiliary drive and
a gasket on the left front planetary
hub.”
He's had troubles, though, with his
Lilliston 284 8-ft. drill. “Before could put it to use I had to realign
most of the hoe shanks with the
packer wheels, Secondly, noticed
either the pitch on the drive sprocket
or the chain pitch wasn’t right on the
fertilizer attachment as the chain
would climb the sprocket.
“After I'd seeded only 120 acres,
the main drive chain from the packers
started jumping off. I find this very
disgusting, as it makes a mess in the
field with unseeded strips. After
checking that no pins had been
sheared, I put the chain back on and
checked to see that it fit the sprockets.
It seemed alright, so decided a small
stone may have made the chain come
off. This happened two more times in
short order, and it seemed to have
something to do with the speed I
travelled. As long as I stayed at half
throttle the chain stayed on, but not at
full throttle. This only lasted about
half a round before the chain came off
at the slower speed.
“After half an hour of careful
checking, I noticed that the clutch
sprocket didn’t line up with the
chain. I moved the secondary shaft to
line it up and figured I had the problem solved. It worked for a while but
then the chain started coming off
again and this time I noticed the
chain was climbing the sprocket. finally called the dealer. He replaced
all the defective parts at no cost, but!
feel the manufacturer is pretty sloppy
with the parts and materials it
‘supplies as well as the way they set
the machine up.”