Chuck Svetlik, Beavercreek, Ore.:
Chuck’s had bad luck with his 1984 Yanmar 276D diesel 4-WD tractor equipped
with a YFL 1000 front-end loader and a
Yanmar 800 backhoe. “At first it was a
pleasure to drive - a powerful tractor for its
27 to 30 hp class. I pulled my baler and a
rototiller with it. After six months, the engine
began losing oil, the power steering went
bad, and it wouldn’t start. Then the 4-WD
failed. The dealer told me the problem was
that a nut had cracked off, but he kept the
tractor for eight days. Three months later, at
180 hours, the rear end housing cracked,
and he kept the tractor for 40 days. Then all
six bolts holding the drawbar assembly failed
and my baler fell away from the tractor onthe-go, fouling up the pto shaft. At 386
hours, the bearings seized and the engine
froze. Another problem is that there’s only
2 in. of clearance, between the air cleaner
and the muffler, where I can see the bottom
of the front-end loader. But the biggest
problem is that the tractor won't always
start, I have to jump start it by bypassing the
starter’s solenoid safety switch, But if the
tractor is in gear when it starts, it could run
me over. I drove 56 miles to return the
tractor for repairs under warranty, and
Yanmar did pick up the tab. But ever since
then, I've been buying hydraulic hoses, as
well as repairing the 3-pt. hitch, front axle
shaft, hub spindles, and steering arms. I'm
getting tired of waiting for parts. The dealer
told me I’m carrying too much weight on
the tractor, that it was buiit to carry light
loads for ‘weekend farmers’. Then why
does ithave a bucket capacity of 1,000 Ibs.?
If Yanmar wants to sell its tractors here in
the U.S.A., they'd better keep parts on hand
and stand behind their product.”