John Deere 2750 utility tractor
What FARM SHOW readers say · 6 Best Buys1 Worst Buy · Tractors
John Deere 2750 utility tractor
6 Best Buys1 Worst Buy“I bought a used Deere 2750 utility tractor with a Deere 240 loader about 30 years ago. It has scooped up thousands of loads of manure over the years and done many more chores around my place. The loader is self-leveling, which is nice for big loads of manure. The hour meter shows 8,600 hrs. and all I’ve had to do over the years is replace the clutch, and diesel injector pump, and do a couple other small repairs. Very pleased with how it has performed.
“About 8 years ago, I purchased a used Ford New Holland 4030 utility tractor with a loader. It’s a good tractor, but when I started using it like my old 2750, the loader brackets broke and had to be reinforced. However, it’s built low to the ground and easy to get up on, which is nice when you’re getting on and off several times a day.”
“In 1995 I bought a used Deere 2750 tractor equipped with a 75 hp engine that had 3,700 hours on it. Over the years I’ve had nothing but problems with this tractor. Little things like the ignition not working after shutting off the engine, and the alternator not charging after starting the engine.
“The worst problem occurred at 6,553 hours when the transmission oil seal went out and had to be replaced. Oil was leaking on the ground. About 1,400 hours later the same problem happened again, and this time I had the tractor repaired at a different shop. That was last August. Last March - about 63 hours later - the seal went out again. Three repair jobs cost me a total of about $12,000. As a result, I traded the tractor off on a newer Deere 6400 model.”
Jim Haines, Bremen, Ind.: Jim says the best piece of equipment he’s purchased in 40 years of farming is his 1989 Toyota 4-WD pickup. “I’ve put 90,000 miles on this pickup, most of them on our farm or on “It won't start when it gets below 40°, even if we use ether.” our hunting preserve, and all we've ever done to it is replaced the front brakes and kept it lubed. “My worst buy is my Deere 2750 tractor. It won't start when it gets below 40 degrees, even if we use ether. All I can do is hope for the best and expect the worst.”
Rock Francis, Greeley, Colo.: “Green just keeps saving me green,” says Rock about his best buy, a Deere 2750 tractor equipped with MFWD he bought new in 1983. “I’ve done everything with it haying, plowing, discing with a 14-ft. disc, mowing hay. It does it all.”
Peter Steranko, Stenen, Sask.: “My 1981 Massey-Ferguson 4840 4-WD tractor has 5,000 trouble-free hours. “T'm well satisfied with my 1985 Deere 2750 MFWD tractor. It has a lot of power and traction and is easy to maneuver in corrals. It’s also fuel efficient. I use it with my 245 quick-tach loader which comes off easily and quickly. I also like the self-leveling quick-tach bucket and the bale fork, I don't think they could do much to improve this loader. have 9,000 hours on the tractor and loader and they've both performed great.” Gary Eichhorn, Parkersburg, W. Va.: “My best buy is my 1992 Roof VP-75 self-propelled lawn mower equipped with a 30-in, deck and a 26-in. semi-open deck (Roof Equipment Mfg. Co., 11660 Sterling Ave., Riverside, Calif, 92503), The 30-in. deck has caster wheels on front and will mow 2-ft, tall grass without plugging up. I also use it to cut light brush on rough terrain. The caster wheels allow me to turn on a dime using only one hand, The semi-open deck will cut brush over 6 ft. tall and up to in. thick. [use it in the fall when the brush is beginning to die. “It has 26-in. drive wheels so it has enough clearance to go through or over almost anything including ditches, ruts, groundhog holes, small stumps, rocks, and 7 to 8-in. dia, logs. The 8 hp engine has plenty of power, and the round deck lets me cut up to 12 in. tall grass and blow the clippings onto uncut grass without plugging up. The only time ever stall the engine by cutting this way is when the clippings are about 8 in. deep and have the consistency of mud.”
Louis Klusinske, Wild Rose, Wis.: Louis is well satisfied with his 1987 Deere 2750 tractor. “It's fuel efficient and has been trouble-free except for a leak in the power steering system, My dealer fixed it immediately.”
David Livesay, Porter, Okla.: “My Westfield drill fill works like it’s supposed to and is a great labor saver. I wouldn't do without it if it cost twice what I paid. “My 1983 Deere 2750 tractor is a pleasure to drive, but the first 1,800 hours were very expensive. I had to spend about $1,800 on repairs. There were a lot of electrical problems that took the company several “It's a great labor saver. I wouldn't do without it if it cost twice what I paid.” years to correct. The crankcase filled with water. We thought that the problem was a head gasket so we pulled the head in our shop and found a hole in one sleeve. The tractor was built during the strike at Deere. We never did get any help from the company. One block man even told me that we shouldn't have pulled the head ourselves. It shouldn't have made any difference because the problem was with the factory work, not ours. We've put another 1,800 hours on the tractor with no problems.”
Own a John Deere? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.