Case + 2 more
Melvin Frueh, Donnellson, Iowa: “It was alemon from the first hour on, with bolts falling out, the electrical system shorting out, power steering locking up and the transmission oil filter plugging every five hours," says Melvin about his ‘‘worst buy” 2390 Case tractor. “When they tore it down after 60 hours, they found that some wear washers in the rear end had been left out at the factory. The dealer was helpful in getting things right, but the tractor traded in — a 1370 — was nearly the same way. In 800 hours, it was down at least six times.”’ On the plus side, Melvin salutes his International 820 grain platform. “You can get nearer to the ground to get those low-standing soybean pods and make the field look as if you cut it with a lawn mower. Also, the cutting knife is faster so you can drive up to 4.5 mph and not strip the stems off. I've even been in a field with a John Deere row crop head and done just as good a job, yet can still use my head for small grain and drilled soybeans, which you can't with the Deere model." linate W. E. Cox, Temple, OkL: “The worst buy I ever made was a Krause chisel plow. The hitch was so weak had to have a welder weld it before had plowed 100 acres. That cost $50. Also broke two rock shaft clamps which cost $20 each. The bolts were too weak. The dealer wouldn't do anything unless the blockman approved, The blockman wouldn't approve so called the president of the company, who said he would see what he could do. I guess he couldn't do anything, at least he didn't. traded the thing off and got a John Deere.” On the plus side, Cox says “my best buys were two 6030 John Deere tractors."