“My father, Irvin Fultz, is an automotive products distributor for CPR Engine Products (The S & S Group, 1018 Barnett Road, Columbus, Ohio 43227 ph 614 235-2773; email: [email protected]; website: www.cprauto.com). We think all their products are best buys, especially their diesel fuel conditioner (Irvin Fultz, 10503 W. 100 S., Hope, Ind. 47246 ph 812 663-9307). My father supplies several local school districts with diesel fuel conditioner for their bus fleets. These products actually perform as advertised. I use the diesel fuel conditioner in my Deere tractor and also in my Cummins engine-powered Dodge pickup. It keeps the fuel from gelling and also improves fuel efficiency.
“There’s even a kit you can purchase to use the conditioner in your car. You use one bottle in the gas tank, one bottle in the oil, and one that gets sucked in via a vacuum hose. After this, your car is guaranteed to pass any U.S. vehicle emissions test (even in California) for the next 200 miles.
“The conditioner actually breaks the water in gasoline down into such small particles that it will combine with fuel and pass through the fuel injection or carburetor. It contains no alcohol. My family had a garage for 20 years and we had little faith in additives (either oil or fuel) until we started using these products. They’re made by a small company in Ohio.”
On the minus side, he lists his 1995 Honda Accord EX equipped with a 2.2-liter V-tec engine and 4-speed automatic transmission. “The engine needed a lower end rebuild at 50,000 miles. The electrical system had a lot of problems from the battery all the way back to the tail lights. It also had rust problems in the rear quarters. I’ve owned 1978 and 1985 Accords, both of which went almost 300,000 miles and excelled in every way. The 1995 model performed like a newborn colt on ice.”