Real farmers rate what they bought, from FARM SHOW MagazineSubscribe  ·  Free issue  ·  Send us your Best or Worst Buy
Subscribe to FARM SHOW
Home › Brands › Kroil

Kroil: what farmers say

7 reports in FARM SHOW · 6 Best Buys1 Worst Buy

Kroil (general)

3 Best Buys0 Worst Buys
Feature storyBest Buy
William, Jenkinsburg, Ga. · Vol. 30, No. 2 (2006), p. 13 · Full story at FARM SHOW →

“Gempler’s rust remover and rust converter removes rust better than any other product I’ve ever used (ph 800 382-8473; www.gemplers.com).”

Read the whole story →
Best Buy
James Wilhite, Jefferson, Georgia · Vol. 27, No. 5 (2003), p. 12

“Kroil is the best penetrating oil I have ever used. I have used several other name brand oils over the years and Kroil beats them all 2 to 1.

“Not only will it loosen frozen threads and stuck screws, but it will also dissolve grease, oil, dirt, and rust. “It can do so many things that it will never be replaced in my toolbox.” (website: www.kanolabs.com).

Best Buy
Lowell Patterson, Eighty-Four, Penn. · Vol. 26, No. 2 (2002), p. 16

“Lowell’s impressed with Kroil, a penetrating lubricant (Kano Laboratories, Box 110098, Nashville, Tenn. 37222 ph 615 833-4101; Website: www.kanolabs.com). “I used it mixed with 30-weight non-detergent motor oil to repair a badly rusted 1982 Ford pickup. The pickup’s kingpin began to seize a while ago which caused increased binding and made it hard to steer. The grease zerk wouldn’t take grease. I couldn’t justify the proper repairs so I was in a real fix.

“I sprayed Kroil into the yoke seams, jacked up the wheel, and worked the lubricant in by steering right and left with the engine running. I waited 15 minutes or so but there didn’t seem to be any improvement so I went into the house. Two hours later, when I went back out and got in the pickup I noticed right away that it steered much easier. I had to repeat the treatment twice more over the next few days before the grease zerk began to take grease.

“I used this same procedure on an old Ford F600 freight truck that belonged to a cousin. The truck was almost unsteerable, and he had to drive it from Pennsylvania to California. I applied Kroil to all the linkage and joints which solved the problem in short order. The company claims Kroil will creep into a joint as tight as one millionth of an inch. It sure helps on tight stuff.

“Our Jonsereds turbo chain saw is a best buy. The only repair it has needed was to the crank assembly. Otherwise this chain saw has performed superbly.

“My Porter-Cable circular saw and 1/2-in. heavy duty drill are both outstanding tools. I do a lot of home improvements so I can’t tolerate poor performance in power tools.

“I want to warn readers to avoid power drills with Rohti German-made drill chucks - I can guarantee they will fail. These chucks are found mostly on 1/2-in. hammer drills sold by Milwaukee, Bosch, Dewalt, and Sears Craftsman. The problem is that the chuck weakens rapidly to the point where it’s impossible to keep it tight for even a few revolutions. If anyone has such a tool they should remove the chuck, send it back to the tool manufacturer, and ask for an American-made chuck. I did that for a Milwaukee drill and got a good chuck.

“I’m intrigued with Hammerite paint (MasterChem, Box 368, Barnhart, Mo. 63012 ph 800 325-3552). It might be the only paint that can be successfully painted directly over rust. It has powdered glass in it which makes it durable.“ 3,500 miles. It uses less than a half quart of oil between oil changes.”

Kroil penetrating fluid

0 Best Buys1 Worst Buy
Worst Buy
Henry S. Yoder, Meyersdale, Penn. · Vol. 46, No. 6 (2022), p. 12

“My 1960’s Deutz 3006 tractor performs very well, doing as much work as two tractors but using the fuel of one.

“My 1989 Deutz tractor is equipped with a loader and has no problem lifting 1 ton and performs better than much larger tractors.

“Kroil penetrating fluid is my worst buy. It’s failed every time and I’ve used three cans already.”

Kroil penetrating lubricant

1 Best Buy0 Worst Buys
Best Buy
Robert Marshall, Somerset, Mass. · Vol. 40, No. 3 (2016), p. 15

“I think Kroil penetrating lubricant is the best on the market (www.kanolabs.com; ph 800 311-3374). You can buy it in an aerosol can or by the gallon. It never lets me down. Wherever there’s corrosion, this oil will work through it.”

Kroil rust solvent

1 Best Buy0 Worst Buys
Best Buy
R. Allen, Clare, Mich. · Vol. 40, No. 2 (2016), p. 13

“I think Kroil rust solvent and lubricant is a great product for farmers (www.kanolabs.com; ph 800 311-3374).

Kroil industrial strength penetrating

1 Best Buy0 Worst Buys
Best Buy
R. W. Ellis, Seymour, Ind. · Vol. 29, No. 4 (2005), p. 14

He likes to use Kroil industrial strength penetrating oil to loosen frozen metal parts (Kano Laboratories, Nashville, Tenn. ph 615 833-5790; www.kanolabs.com). “It penetrates into 1 millionth inch spaces to dissolve rust and lubricate quickly. According to the company, as long as the surface is wet with Kroil it won’t corrode. It’s available in aerosol cans that squirt a stream 3 ft. The company also offers a wide variety of other lubrication products.”

Read every report in full

FARM SHOW has run reader Best & Worst Buys since the beginning.

Subscribe to FARM SHOW