Louie Christensen, Nome, N.Dak.: “My
DMI ‘Tiger Two’ 7-shank deep ripper was
in the shop for warranty repairs for two of
the first three months after I bought it last
August,” says Louie, who operates the ripper at 14-in. depths. “Our dry fall should
have been ideal for shattering the hardpan.
However, the ripper couldn’t handle rocks
despite being equipped both with spring
tripsand shear bolts. After 475 acres, four of
its seven shank assemblies were sprung.
The geometry of the spring trip is faulty
because it requires more upward motion
than backward motion to trip, so it works
only on ‘round-top’ rocks. I use grade no, 2
shear bolts as recommended, yet! still have
20 Ibs. of sheared bolts lying in the tractor
cab to prove that they don’t work when they
hook a rock solidly. The shank assembly
bends sideways and tries to go around the
rock. Side thrust is transferred upward to the
draft links and is multiplied by the leverage
involved, However, the links can’t take that
much stress in that direction. The bent shanks
ride out of the ground causing the machine
to pull crooked, Asa result, soil abrasion is
transferred to soft steel on the side of the
point instead of on the hard surfacing at the
tip. DMI replaced all bent parts, but with
duplicates of the original. I fail to see how
this can remedy the problem because the
design has been proven inadequate. By next
fall the warranty will have expired which, I
suppose, will cure the problem for DMI.”
On the positive side, Louie ranks his
Case-IH 496 spring-cushion 28 1/2-ft. wide
tandem disk as a “best buy”. “Although I
pull it at 6 1/2 mph, rock damage has been
minimal. The lengthwise cushioning of the
suspension members, as well as the vertical
movement of the gangs, absorbs enough
shock to make disk or spool breakage a
rarity. My only criticism concerns the gang
hanger bearings. Flexing of the cushion
springs causes some of the spherical race
bearings to turn in their retainers, resulting
in misalignmentof the grease fittings so that
they no longer accept grease. There’s no
way to correct the misalignment.”
Another “best buy” is his 1979 Steiger
$T270 tractor powered by a 3306 Caterpil(
/ 3-/— FARM SHOW - 13 Best & Worst
(
lar engine. “I've made only minor repairs to
an injector tip. At nearly 5,000 hours the
engine seems to work as good as ever and
emits no diesel smoke unless pulled below
governed speed.”