Real farmers rate what they bought, from FARM SHOW MagazineSubscribe  ·  Free issue  ·  Send us your Best or Worst Buy
Subscribe to FARM SHOW
Home › Vol. 41, No. 2 (2017) › Feature
Feature storyBest Buy

“Best Buy” New Holland Self-Propelled Square Baler

A FARM SHOW reader · FARM SHOW Vol. 41, No. 2 (2017), page 13

“It has made more than a half million bales of hay over the years. It just proves how long any machine will last with a little care,” says Charles Brown, New Lebanon, N.Y., about his 1962 New Holland self-propelled baler.

“My dad and I bought this baler on my 32nd birthday, and both the baler and I are still going strong. This machine has been a real prize and has required only routine maintenance. About 20 years ago we replaced the original Wisconsin VR4D engine with a 4-cyl. Deutz diesel. This has been a great baler.”

Contact: FARM SHOW Followup, Charles Brown, 35 Old Route 20, New Lebanon, N.Y. 12125 (ph 518 794-8861).

Contact: FARM SHOW Followup,

Read more at FARM SHOW →
“Best Buy” New Holland Self-Propelled Square Baler
Photo: FARM SHOW

Reader comments

New Holland self-propelled baler

5 Best Buys1 Worst Buy
Worst Buy
Don Miller, Raleigh, N. Dak. · Vol. 38, No. 1 (2014), p. 12

“We have baled with New Holland balers for many years. In 2012, we bought a new BR7090 New Holland and it’s the worst machine I’ve had on my place in 40 years of ranching. We can never get it to tie twine correctly and we always have trouble with the pickup attachment. In addition, the belts do not track properly. We have been unable to get satisfaction from our dealer or New Holland. What do they tell me? ‘We understand.’ But that’s as far as it goes.”

Best Buy
Virgil Storm, Lucas, Iowa · Vol. 34, No. 5 (2010), p. 13

“I’ve used New Holland round balers for the past 2 1/2 years. They’re the best money can buy.”

Best Buy
Francis Henderson, Brinston, Ontario · Vol. 30, No. 3 (2006), p. 15

“My 2004 New Holland TG210 tractor is a pleasure to operate. No problems.

“My 2005 New Holland big square baler works like a dream and has been trouble-free.

“My 2004 J-Star Van Dale 53-bu. feed cart is my worst buy. It has a bad paint job, a very loud muffler, and the 9 hp Honda engine has caused nothing but trouble. Gas keeps getting into the oil, but the dealer told me I had to go to the company for help. I’ve had to change the needle and carburetor, all at my own expense. The company gave me every excuse in the book why the problem was my fault. They also said that I have to turn the gas off whenever the machine is not in use. I have six other Honda engines, and I don’t have to shut the fuel off on any of them.”

Best Buy
Daniel Glick, Willow Street, Penn. · Vol. 15, No. 5 (1991), p. 14

Daniel Glick, Willow Street, Penn.: Daniel bought his “best buy” New Holland model 311 baler in 1988. “After having the service man out two or three times to adjust the knotters, we had a good baler. The following spring we baled 4,400 bales before it missed a knot!”

Best Buy
Jack Rarig, Catawissa, Penn. · Vol. 14, No. 2 (1990), p. 14

Jack Rarig, Catawissa, Penn.: “Wood cutting is an easy all-day job with our 1989 Stihl 028 Wood Boss Super chain saw,” says Jack. “It's lightweight, quiet, uses very litle fuel, and is equipped with a chain brake and low-kickback bar and chain. Starts even in 20° below temperatures.” Jack’s “worst buy” is his 1988 Massey Ferguson 220 square baler. “The knotter stopped cutting twine on the LOth to 15th bale, but we didn'tnotice the problem until we saw 50 to 100 ft. of twine trailing behind the baler, attached to the last tied bale. It misses 2 or 3 bales each time this way, Our dealer can’tsolve the problem. Glad I didn’t trade my old New Holland baler.”