Massey Ferguson 285 tractor
What FARM SHOW readers say · 4 Best Buys0 Worst Buys · Tractors
Massey Ferguson 285 tractor
4 Best Buys0 Worst Buys“My best buy is my Kubota B8200 4-WD backhoe grader equipped with an 18 hp engine and 12-in. rear bucket. It does a nice job.
“My 1979 Massey Ferguson 285 tractor has only 670 hours on it and is still in like-new condition. I bought it equipped with a 54-in., 6-way hydraulic-operated blade, a 540 rpm pto, and a Cat. I 3-pt. hitch. I also use it with a 52-in. Woods Bros. rototiller, a used single shank subsoiler that’ll go 24 in. deep, and a 2-section spring tooth harrow. The tractor handles them all with no problems.”
“Our Massey Ferguson 285 tractor, bought in 1983, has been split so many times I think it should have been built with a quick-disconnect system at the transmission. It’s about as dependable as a scud missile and only slightly less costly. Major repairs have included replacing the rear planetaries, the pto clutch and splines, one front and two rear transmission bearings, and the 3-pt. internal lift cylinder. We also rebuilt the fuel injection pump and fixed the pto brake four times. That’s about $13,000 worth of repairs on a $24,500 tractor along with endless downtime. All we’ve ever gotten from Agco is a ‘You bought it, it’s your problem’ attitude.”
Paul Sweeney, Douro, Ontario: Paul’s satisfied with his 1983 Massey Ferguson 285 tractor but has hada few problems. “We drained the hydraulic fluid at 60 hours and found the remains of what seemed to be a brass washer on the filter screen, Later the fuel tank collapsed because the breather valve wasn't working in the tank cap. In both cases the dealer reacted quickly, The big 4-cylinder engine makes the tractor vibrate uncomfortably. It’s also so noisy that I have to wear ear plugs. However, it’s economical to operate and so far I’m happy with it. If I were in the market for a new tractor I'd consider another Massey Ferguson in the same horsepower range because they’rereliable and have good dealer service.”
Jon Peters, Emmett, Mich.: “We bought it nine years ago and the only problem we ever had was with a failed shifting fork. After 10,000 hrs. of use, it’s never had a wrench on the engine,” says Jon, pleased with the “After 10,000 hrs., it’s never had a wrench on the engine.” performance of his Ford 8600 tractor. We also have a 1978 Ford 9700 that has provided 7,000 hrs. of similar good performance.” On the negative side, Jon had trouble with a Massey Ferguson 285 tractor bought in 1976. “We owned it for 2,200 hrs, and had to replace the water pump, hydraulic pump, fuel pump, head gasket, battery, starter, four spindles on the front end, and a cracked oil pan. We also rebuilt the engine. Dealer service was fair but the tractor was poorly put together.”
Own a Massey Ferguson? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.