Ford 6710 tractor
What FARM SHOW readers say · 2 Best Buys1 Worst Buy · Tractors
Ford 6710 tractor
2 Best Buys1 Worst BuyOtis is disappointed with his 1985 Ford 6710 tractor. “I bought it new and have changed the oil regularly every 50 hours. At 2,638 hours, the crankshaft and three rods went bad, even though I had never worked the tractor hard. I sent a letter to the company but they never even acknowledged receiving it. However, I know they got it because in the letter I praised our local dealer who had put in a new engine in the tractor - at a cost to me of $7,000 - and a New Holland rep showed them my letter. Another problem is the front axle spindle is built too light. I’ve broken three spindles so far, and the last time one broke the tractor rolled over. It’s not easy to get out of a tractor cab when the tractor is lying on its side.
“I needed bearings for the tractor one Saturday but the dealer didn’t have any. He said I should go to a Napa auto parts store because they have the same bearings this tractor uses. Does it make sense for a tractor axle to use the same bearings as a car? Talk about cutting corners.”
Otis A. Ueckert, Bellville, Texas: Otis has had good luck with his New Holland 852 round baler. “I bought it used for about one fifth the price of a new 855 model. I’ve made 543 bales with it while spending less than $100 on repairs. “My 1985 Ford 6710 tractor is equipped witha 777F front-end loader. I paid $26,500 for the tractor. I like it fine except that the front wheel bearings failed. They were made by Toyota in Japan. The dealer didn’t have them in stock so I had to buy them at NAPA Auto parts. Think of it - installing car parts on a tractor equipped with a loader. When thebearings wentout again I ruined a spindle, I'm switching to Timkin bearings because they’re made in the U.S.A.”
Donald G. Chamberlain, Bowling Green, Mo.: He's happy with his 1983 Ford 6710 tractor. "This tractor replaced a 1980 6700 Ford. It has a little more horsepower but much better fuel economy. The hydraulic system is also much improved with increased capacity and redesigned valves. The pto clutch engages smoothly without jerking the implement. Hardly any bugs yet and a pleasure to operate."
Own a Ford? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.