New Holland 358 mix mill
What FARM SHOW readers say · 0 Best Buys2 Worst Buys · Tractors
New Holland 358 mix mill
0 Best Buys2 Worst BuysMike Bailey, Saint John, Wa.: Mike's unhappy with his New Holland 358 grinder/mixer. “The hand crank on that raises or lowers the unloading auger is a man killer. It has a lock inside to release the auger. There’s just enough room to get your finger inside to release the lock to let the auger down, Everyone who has used this machine at one time or another has had the lock fail to latch, causing the auger to slam down and either hit the operator in the face or bruise his fingers as the crank spins around.”
Harold Weppler, Morse, Sask.: “It makes the best round bales on the market,” says Harold, owner of a 1988 Deere 430 round baler. “It’s simple to operate and requires little maintenance. “My 1984 Deere 7721 pull-type combine is also a best buy. It does a good job, is easy to adjust, has lots of capacity, and holds its value.” On the negative side, “The feeder chains on my 1989 New Holland 358 mix mill were installed backward. The mill's engage pin sometimes flies out under a load. The dealer couldn't fix it. Ever since Ford took over New Holland the quality has been poor. “My 1986 Case-IH 5600 cultivator is also a worst buy. Two sets of shanks had to be replaced and the wing lift binded and fell down, bending the axle. The wing lift holdup tower tore out of the frame and left hoses dragging. The walking beam axles had to be rebuilt twice.”
Own a New Holland? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.