Real farmers rate what they bought, from FARM SHOW MagazineSubscribe  ·  Free issue  ·  Send us your Best or Worst Buy
Subscribe to FARM SHOW
Home › Brands › Magnum

Magnum: what farmers say

3 reports in FARM SHOW · 3 Best Buys0 Worst Buys

Magnum fractional calipers

1 Best Buy0 Worst Buys
Best Buy
Paul Stanley, Maple Ridge, B.C. · Vol. 46, No. 3 (2022), p. 13

“My ‘best buy’ is a pair of 12-in. Magnum fractional calipers that I purchased at KMS Tools in Canada. The calipers can read millimeters, decimal inches and fractional inches and you can read depths with them. Some digital calipers do not allow for that.”

Magnum cutting torch featured

1 Best Buy0 Worst Buys
Best Buy
Lee Vrzalik, Innis, Tex. · Vol. 27, No. 3 (2003), p. 12

“I wanted to tell other FARM SHOW readers about my experience with the Magnum cutting torch featured in the last issue of FARM SHOW. After buying one and using it, I don’t recommend it for the average farmer. It burns very hot but it’s difficult to control and expensive to run. I work on transmissions and thought it would be ideal for cutting gears and other parts. But it burns so fast there is very little time to work, and the rod must be held at a precise angle. Very difficult to use.

“I called the company in California and they weren’t much help. I’m heading to California soon and asked if I could stop by for some pointers but they said they don’t do that and that I should look at the instructions on their website. That didn’t help much although I found out the torch is primarily designed as an underwater cutting torch. When I asked about returning it, they said if I had started it up it could not be returned. I don’t think this is the right torch for the average guy.”

Magnum cutting torch

1 Best Buy0 Worst Buys
Best Buy
Chad Travis, Drasco, Ark. · Vol. 27, No. 4 (2003), p. 13

“In the last issue of FARM SHOW a Texas man said that based on his experience, he wouldn’t recommend the Magnum cutting torch for the average farmer. He said it burns very hot but is difficult to control and expensive to run. As a certified welder and diesel technician, I’ve had a similar experience with my Magnum torch. It has a lot of power, but it has some drawbacks. I don’t recommend that anyone get rid of their oxygen, acetylene, or plasma cutter before buying a Magnum. However, it burns hot and works good for penetrating thick material beyond conventional means. I’ve actually used it to cut holes in rocks up to 6 in. thick and to cut cast iron. One time I used it to cut a notch in a 27-in. dia., 4-in. thick flywheel. It also works good for washing out large welds. However, the rods for it are expensive and don’t last long enough. It throws a lot of fire and sparks.”

He’s “generally satisfied” with his 1996 Deere 5300 4-WD tractor but says it could use a few improvements. “It has adequate power and hydraulics. However, I think this tractor is too light on back to be used with a front-end loader. The grill and fenders are made of plastic, and the seat is poor quality. I built a bumper and grill guard and added a pair of 3 by 5-in. lights on the fenders. I added a 6-hole trailer plug so I can hook up implement lights. I built a skid plate that goes from the bumper to the drawbar. I also made hose protectors to cover the hydraulic hoses on the loader.”

Read every report in full

FARM SHOW has run reader Best & Worst Buys since the beginning.

Subscribe to FARM SHOW