Ellis 1600 metal-cutting saw
What FARM SHOW readers say · 2 Best Buys0 Worst Buys · Chainsaws & Saws
Ellis 1600 metal-cutting saw
2 Best Buys0 Worst Buys“My Ellis 1600 metal-cutting saw is built heavy-duty. It cuts straight or at angles up to 45 degrees. If you do a lot of metal fabrication, you should have one in your shop.”
“I like my 2009 Ellis 1600 portable metal-cutting bandsaw much better than the chop saw I had been using (www.ellissaw.com; ph 800 383-5547). This is a dry saw with no messy water-based oil to deal with and it works automatically, which saves a lot of time. It automatically shuts off when it’s done with the job, so I can just ‘set it and forget it’. I’ve used it on everything from 4-in. stainless steel tubing to 8-in. schedule 40 pipe, which I use to build ranch gates for friends and neighbors. My daughter and son-in-law recently finished building a big arena, and all the gates inside it were made with this saw.
“This saw works great for cutting at a 45-angle which adds strength, makes the gates look neat and professional, and doesn’t leave any open ends exposed to the weather.
“The saw comes with a small hydraulic cylinder that I use to adjust the blade down pressure. As a result, I can slow the saw down when cutting very hard material or open it up when cutting schedule 80 pipe.
“This saw is also very accurate. I’ve made 1,500 to 2,000 cuts with this saw and all of them were accurate down to 1/32 of an inch. I can make repetitive cuts with the saw, and 45-degree angle cuts to the left or right.
“I paid about $1,300 for this saw which is quite expensive, so I gave it a lot of thought before I bought it. In my opinion a chop saw is nothing but a fire hazard because of all the smoke and dust it creates. The only reason I keep my chop saw around is to cut hydraulic hose.
“My son-in-law is a horseshoe farrier and uses my saw to build farrier’s tools. He likes it, too.”
Own a Ellis? Tell FARM SHOW how it’s held up.
Your report could appear in a future issue.