Shoup Mfg: what farmers say
4 reports in FARM SHOW · 3 Best Buys1 Worst Buy
Shoup Mfg (general)
3 Best Buys1 Worst Buy“I ordered a tractor cab interior kit from Shoup Mfg. When it came, the foam backing on the vinyl was deteriorated and falling apart. I contacted Shoup, and they said all they could do was sell me another kit at their cost. I said ‘no’ because I couldn’t charge my customer for two kits. They should’ve replaced it at no charge. Why would I buy another?”
Also on the negative side, “I bought a hydrogen generator from Andrew Herrold for my diesel motorhome. I did everything he said to do to adapt it to my engine but never saw any improvement in mileage. I spent a lot of time and money on this when I should have just used the money to buy diesel fuel. I was told to send the unit back and I’d get a refund. I sent the unit back but didn’t get my money back.”
“My 2002 Ford F-350 pickup equipped with a 7.3-liter diesel engine has about 112,000 miles on it. It gets 12 mpg loaded and 16 to 17 mpg empty. The radio has good sound quality and the air conditioner works good. I change the oil on this vehicle every 5,000 miles or so. I had to replace a rear driveshaft seal, but otherwise this pickup has required only routine maintenance.”
On the “worst buy” side, “My 2015 Kawasaki 4010 utility vehicle is smaller than my previous 1999 Kawasaki model. I paid about $11,000 and bought it because I had good luck with the older model and because it came with a 3-year warranty, whereas most manufacturers provide just a 6-mo. warranty. According to the warranty, at 75 hrs. I was supposed to bring the vehicle in to have the valves adjusted. However, I was surprised to find this job was going to cost me $80, and if I didn’t have the work done the warranty would be void. What kind of warranty is that?
“Another problem was that the radiator hose came off due to an improperly installed hose clamp, which allowed air to get into the cooling system. Unfortunately, the water pump is located above the radiator so the vehicle’s front end has to be jacked up 2 ft. off the floor in order to get air out of the cooling system. They wanted to charge me for that repair, too.
“Whenever I need new parts, such as bearings for cutters and plows, I order them from Shoup Mfg. (ph 800 627-6137; www.shoupparts.com). They can save you a lot of money. For example, I was able to buy a starter for an old Deere tractor for $160 whereas Deere charges $400 for the same part.”
“I bought two combine belts from Shoup Mfg. and they’re my worst buys. The belts separated and failed in less than three hours.”
“My best buy was my Deere 535 round baler. “My worst buy is my Marliss no-till drill. I followed the company’s suggestions on how to get it to plant at the right depth for two years. I wanted wider press wheels but the company would only sell them to me at $61 apiece. I finally bought new wide press wheels from Shoup Mfg. for $26 apiece. Now I have to solve the problem of having to change two sets of sprockets and chains whenever I switch from planting oats to beans. I also had to straighten out the guides on the press wheel springs - the guides were welded together wrong at the factory and are half worn out after planting only 200 acres.”
Read every report in full
FARM SHOW has run reader Best & Worst Buys since the beginning.